Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Doublet Troubleshooting
#7
OK, thanks for the suggestions. I was transmitting on low power in LSB, the radio said I had an SWR 2-3:1, but the needles on the tuner were barely moving. I guess indicating a super high SWR. I roughly measured my feed line and it’s about 55’, in the danger zone I guess. The experts suggests 80’ is a safe length. I’ll add 25’ loosely coiled in the house and see what that does, and tune on CW. The ladder line does cross a drain pipe perpendicularly, about 3”, also the dipole (65’ on both sides of the feedpoint) brush against some branches, the wire is insulated.
Doug McDougall Smile
Reply


Messages In This Thread
Doublet Troubleshooting - by Ve3dgy - 2021-01-09, 17:59:04
RE: Doublet Troubleshooting - by Rob_Walker - 2021-01-09, 18:48:43
Ve3dgy - by Ve3dgy - 2021-01-09, 19:46:59
RE: Ve3dgy - by Rob_Walker - 2021-01-09, 22:03:03
RE: Doublet Troubleshooting - by VA3KOT John - 2021-01-09, 23:56:08
RE: Doublet Troubleshooting - by VA3KOT John - 2021-01-10, 09:49:42
Ve3dgy - by Ve3dgy - 2021-01-10, 13:03:52
RE: Ve3dgy - by VA3KOT John - 2021-01-10, 13:31:42
Ve3dgy - by Ve3dgy - 2021-01-10, 20:36:46
Ve3dgy - by Ve3dgy - 2021-01-11, 17:05:13
RE: Ve3dgy - by VA3KOT John - 2021-01-11, 18:18:14
RE: Doublet Troubleshooting - by Tom VA3TS - 2021-01-12, 10:31:14
Ve3dgy - by Ve3dgy - 2021-01-12, 14:56:32
RE: Doublet Troubleshooting - by Tom VA3TS - 2021-01-12, 18:42:02
RE: Doublet Troubleshooting - by Ve3ids Don - 2021-01-17, 19:06:32

Forum Jump:


Users browsing this thread: 3 Guest(s)